Joel Challis e9b8929357 Migrate build target markers to keyboard.json - Misc (#23612) 2 лет назад
..
keymaps 74223c34a9 Remove legacy keycodes, part 6 (#18740) 3 лет назад
rev1 831deac212 Migrate build target markers to keyboard.json (#23293) 2 лет назад
rev2 e9b8929357 Migrate build target markers to keyboard.json - Misc (#23612) 2 лет назад
config.h 569b0c70be WS2812 PWM: prefix for DMA defines (#23111) 2 лет назад
halconf.h 926389f3a7 Keyboard/grandiceps (#11933) 5 лет назад
info.json 32136afe24 Change to `development_board` (#21695) 2 лет назад
mcuconf.h 926389f3a7 Keyboard/grandiceps (#11933) 5 лет назад
readme.md d2accb48e7 RESET -> QK_BOOT keyboard readme (#18110) 4 лет назад
rules.mk 9c1662f8f9 Migrate build target markers to keyboard.json - TUV (#23514) 2 лет назад

readme.md

grandiceps

grandiceps

ARM split keyboard with RGB underglow and encoders.

  • Keyboard Maintainer: vattern
  • Hardware Supported: f411 blackpill
  • Hardware Availability: grandiceps

There are two versions of the Grandiceps. Please use the appropriate firmware for your board.

  • Revision 2 has I2C eeprom and support for a Pimoroni trackball.

Make example for this keyboard (after setting up your build environment):

make tkw/grandiceps:default
make tkw/grandiceps/rev2:default

Flashing example for this keyboard:

make tkw/grandiceps:default:flash
make tkw/grandiceps/rev2:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset buttons: Hold down the BOOT0 button and then briefly press the NRST button on the BlackPill PCB.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available