readme.md 2.1 KB

DGK6X = Venus, Hades, Galaxy, etc.

This DGK6X code is shared between the ANSI variants of Venus, Hades and Galaxy keyboards.

  • Keyboard Maintainer: J-Sully and dkjer
  • Hardware Supported: Durgod Venus, Hades or Galaxy board with STM32F070RBT6
  • Hardware Availability: Venus, Hades and Galaxy

Instructions

Build

Instructions for building the Venus, Hades and Galaxy firmware can be found here:

Initial Flash

For first Flashing from initial Stock's Firmware

  1. Back up original Firmware Image:
  2. Unplug
  3. Short Boot0 to Vdd (See below)
  4. Plug In USB
  5. Make a Flash Image's Backup in case you wanted to restore the Keyboard to Stock's Image:

    • Using dfu-util:

      dfu-util --list dfu-util --alt 0 --dfuse-address 0x08000000 --upload ${OLD_STOCK_BIN}

  6. Flash the QMK Firmware Image.

  7. Put board into Bootloader mode, using the same method as when backing up the original Firmware (above)

  8. Here are a few options for performing the initial Flash:

    • Using QMK Toolbox
    • Using dfu-util:

      dfu-util --alt 0 --dfuse-address 0x08000000 --download ${NEW_QMK_BIN}

You can short Boot0 to Vdd by shorting R19 to C30 on the sides closest to the processor, as shown:

  • Hades & Venus: Shorting Boot0 to Vdd on Hades or Venus

  • Galaxy 75 Shorting Boot0 to Vdd on Galaxy 75

Subsequent Flashing

For repeating Flashing you can use BootMagic:

  • BootMagic Lite has been enabled with Assigned "Esc" key
  • Unplug USB Cable
  • Holding Esc Button
  • Plug in USB Cable, Keyboard should be in ST-Bootloader state