Ryan 7e0299117b Move encoder config to data driven (#19923) 3 år sedan
..
keymaps 74223c34a9 Remove legacy keycodes, part 6 (#18740) 3 år sedan
rev1 201f1a8f47 Move keyboard USB IDs and strings to data driven, pass 2: S-Y (#18093) 4 år sedan
rev2 201f1a8f47 Move keyboard USB IDs and strings to data driven, pass 2: S-Y (#18093) 4 år sedan
config.h 7e0299117b Move encoder config to data driven (#19923) 3 år sedan
grandiceps.c 926389f3a7 Keyboard/grandiceps (#11933) 5 år sedan
grandiceps.h 926389f3a7 Keyboard/grandiceps (#11933) 5 år sedan
halconf.h 926389f3a7 Keyboard/grandiceps (#11933) 5 år sedan
info.json 7e0299117b Move encoder config to data driven (#19923) 3 år sedan
mcuconf.h 926389f3a7 Keyboard/grandiceps (#11933) 5 år sedan
readme.md d2accb48e7 RESET -> QK_BOOT keyboard readme (#18110) 4 år sedan
rules.mk f9aeea64c1 Migrate `MCU` and `BOOTLOADER` to data-driven (#19529) 3 år sedan

readme.md

grandiceps

grandiceps

ARM split keyboard with RGB underglow and encoders.

  • Keyboard Maintainer: vattern
  • Hardware Supported: f411 blackpill
  • Hardware Availability: grandiceps

There are two versions of the Grandiceps. Please use the appropriate firmware for your board.

  • Revision 2 has I2C eeprom and support for a Pimoroni trackball.

Make example for this keyboard (after setting up your build environment):

make tkw/grandiceps:default
make tkw/grandiceps/rev2:default

Flashing example for this keyboard:

make tkw/grandiceps:default:flash
make tkw/grandiceps/rev2:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset buttons: Hold down the BOOT0 button and then briefly press the NRST button on the BlackPill PCB.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available