Ryan 3bf01bb9ed Move QMK LUFA bootloader config to data driven (#19879) 3 years ago
..
keymaps 1cb1a5a374 Remove legacy Grave Escape keycodes (#18787) 3 years ago
config.h 3bf01bb9ed Move QMK LUFA bootloader config to data driven (#19879) 3 years ago
info.json 3bf01bb9ed Move QMK LUFA bootloader config to data driven (#19879) 3 years ago
just60.h 89f7378569 move @yangdigi 's keyboards to a YDKB folder (#15681) 4 years ago
readme.md c6e291c416 Revert RESET-> QK_BOOT in Read Me files where applicable (#19262) 3 years ago
rules.mk f9aeea64c1 Migrate `MCU` and `BOOTLOADER` to data-driven (#19529) 3 years ago

readme.md

Just60

Just60 keyboard produced by Yang. The keyboard comes with a custom Mass Storage Device bootloader and a TMK based firmware from ydkb.io.

To use a QMK based firmware, you might want to install a QMK bootloader. The PCB exposes 6 pins for ISP(In-System Programming), and they are located just under the ATMega32U4 chip. From left to right, the pins are VCC, SCLK, MOSI, MISO, RESET, GND. The GND is the square one. You could program the flash with any AVR programmer, or a Raspberry Pi with avrdude.

Backlight LEDs and Bluetooth are not working yet.

Make example for this keyboard (after setting up your build environment):

make ydkb/just60:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.