Ryan 786ebf8760 Remove requirement for `keymap_steno.h` include in keymaps (#22423) пре 2 година
..
keymaps 786ebf8760 Remove requirement for `keymap_steno.h` include in keymaps (#22423) пре 2 година
config.h 2da0827d4f Remove matrix size defines (#19581) пре 3 година
info.json 5bd68e3695 Move single `LAYOUT`s to data driven (#20365) пре 3 година
readme.md d2accb48e7 RESET -> QK_BOOT keyboard readme (#18110) пре 4 година
rules.mk f9aeea64c1 Migrate `MCU` and `BOOTLOADER` to data-driven (#19529) пре 3 година

readme.md

Splitography

Splitography

A pay what you will compact keyboard intended for use with Plover, free and open source stenography software. This is a low-cost keyboard with minimal packaging and design, and arrives fully assembled, ready to use.

Make example for this keyboard (after setting up your build environment):

make splitography:default

Flashing example for this keyboard:

make splitography:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard.
  • Physical reset button: Briefly press the button on the back of the PCB.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available.

Guide

Splitography quick start video

A short video guide on how to set up the SOFT/HRUF Splitography, a mechanical keyboard intended for use with Plover.

Here is a reference card for the standard keyboard layout:

Reference card

  • While holding down a colored thumb key, the matching colored functions/characters on the remaining keys can be pressed.
  • Bottom edge keys are accessed by holding down both keys.
  • Numlock locks in the Numpad layer.
  • Alt and Shift pressed simultaneously to return to the standard layout.