|
|
5 лет назад | |
|---|---|---|
| .. | ||
| keymaps | 4ebd27002a Keyboard: 5291 firmware to replace the existing soarers controller firmware (#4483) | 7 лет назад |
| .noci | 6368a5697d Exclude more keyboards from CI (#11436) | 5 лет назад |
| config.h | ca7da3866d Merge remote-tracking branch 'upstream/master' into develop | 5 лет назад |
| ibm_5291.c | 4ebd27002a Keyboard: 5291 firmware to replace the existing soarers controller firmware (#4483) | 7 лет назад |
| ibm_5291.h | 4ebd27002a Keyboard: 5291 firmware to replace the existing soarers controller firmware (#4483) | 7 лет назад |
| info.json | 767089384f Resolve a number of warnings in `qmk generate-api` (#12833) | 5 лет назад |
| matrix.c | f5a38b95c1 Remove legacy print backward compatiblitly (#11805) | 5 лет назад |
| matrix.csv | 4ebd27002a Keyboard: 5291 firmware to replace the existing soarers controller firmware (#4483) | 7 лет назад |
| readme.md | 2527fe879f converter/ibm_5291: Configurator support and readme cleanup (#4654) | 7 лет назад |
| rules.mk | 66fe3001e4 Trim firmware sizes from default rules.mk, part 1 (#8027) | 6 лет назад |
A converter for the eponymous keyboard.
Keyboard Maintainer: Listofoptions
Hardware Supported: IBM 5291, Teensy 2.0
Make example for this keyboard (after setting up your build environment):
make converter/ibm_5291:default
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
The pinout is as follows:
IBM−5291−Cable to Pinhead−14
| pin | description |
|---|---|
| 1 | GND |
| 2 | NC |
| 3 | GND |
| 4 | GN) |
| 5 | +5V |
| 6 | D0 |
| 7 | D1 |
| 8 | D2 |
| 9 | D3 |
| 10 | D4 |
| 11 | D5 |
| 12 | D6 |
| 13 | Strobe |
| 14 | Out |
The pins on this connector are organized
IBM−5291−2 Cable with DB15M connector
| pin | description |
|---|---|
| 1,2,3 | GND |
| 4 | +5V |
| 5 | D0 |
| 6 | D1 |
| 7 | D2 |
| 8 | D3 |
| 9 | D4 |
| 10 | D5 |
| 11 | D6 |
| 12 | Strobe |
| 13 | Out |
| 14 | PE |
| 15 | NC |
The above connector is actually numbered so it should be easier to determine where the needed connections are.
To connect to the teensy, the following are pins are needed (if you should choose not set your own):
sources:
http://www.retrocomputing.eu/documents/5291_MaintenanceLibrary.pdf